Down4Sound
DOWN4SOUND JP16.2 GRAY | 3200W RMS - 2 CHANNEL AMPLIFIER
- SKU:
- JP16.2-GY-
- MPN:
- JP16.2-GY-
Description
Take your car audio system to the next level with the DOWN4SOUND JP16.2 GRAY amplifier. Built for bassheads who demand intense low-end response and crisp highs, this amplifier provides 1600W RMS of pure power, ideal for 1-ohm, 2-ohm, and 4-ohm setups. The sleek gray finish adds a modern touch to your system while delivering unparalleled performance.
Key Features:
- Stable into 1 Ohm Mono Load: Delivers steady, high-power performance even at low impedance.
- Bandpass Capable: Supports various speaker configurations for versatile audio setups.
- 4-Way Protection Circuits: Thermal, high & low voltage, speaker short, and DC protection for safe, reliable operation.
- 2 - 0 Gauge Power/Ground Terminals (4 Total).
- Remote Control Included: Comes with a remote bass knob with voltage, temperature, and clipping indicators.
Specifications:
Output Power:
- 4 ohm RMS Power: 600W x 2ch
- 2 ohm RMS Power: 1200W x 2ch
- 1 ohm RMS Power: 1600W x 2ch
- 4 ohm RMS Bridged Power: 2500W x 1ch
- 2 ohm RMS Bridged Power: 3700W x 1ch
- Tested at 14.4V & 1% THD
- Frequency Response: 10Hz – 22.1KHz
- Signal to Noise Ratio: 80dB
- Damping Factor: 160
- Input Sensitivity: 6V – 0.2V
- High Pass Filter: 20Hz – 800Hz
- High Pass Multiply x1, x10 (200Hz - 8kHz)
- Low Pass Filter: 50Hz – 800Hz
- Low Pass Multiply x1, x10 (500Hz - 8kHz)
- Bass Boost Frequency: 20Hz – 80Hz
- Clip In/Clip Out Indicator
- 41 Click Pots for HPF, LPF & Bass Frequency
- Remote Control with Voltage and Temperature Display, Thermal and Clipping Indicator
- Working Voltage: 9V – 15.5V
- Dimensions: 360mm L x 238mm W x 69mm H (14.17 x 9.37 x 2.71 inches)
Warranty Information
Warranty Information
Your new Down4Sound product is covered by 1 limited warranty if purchased from Down4Sound or an authorized Down4Sound dealer. This warranty does not cover improper installation, accidental damage, misuse, abuse, improper wiring, operation of unit outside of listed specifications, or any product that has been modified or repaired by anyone other than Down4Sound. Your warranty covers defects in materials and/or workmanship ONLY and is not an insurance policy. The warranty only covers the original owner of the amplifier.
All warranty returns must be accompanied by the original sales invoice or receipt. You must contact us to request an RMA number prior to sending any returns via the RMA request form on our website. You are responsible for the cost of shipping your product back to us for warranty examination. If your product is covered under warranty, shipping back to you will be at no charge to you – if your product is replaced/repaired outside of warranty you must pay for return shipping and repair bill prior to the return of the product or if no defect is found you are required to pay for return shipping only.
At the sole discretion of Down4Sound your product will be either repaired or replaced when it is being covered under warranty. In the event of shipping damage due to improper packaging on products being returned to Down4Sound the customer is liable for the cost of all damages, necessary repairs, or replacement. Be sure to properly pack your return!
* Extended additional warranty purchased on amplifiers take effect from the date of purchase and must also be stated on original sales invoice or receipt.
Refund/Return Policy: https://www.down4soundshop.com/shipping-returns/
Down4Sound - Hours of Operation
Additional Information
Amplifier Type: |
2 CHANNEL |
Amplifier Color: |
GRAY |
Product Type: |
Amplifier |
